Your pool doesn’t only require daily cleaning from cleaning tools, but it will also need an extra push, with you investing in a pool pump to keep the water filtered and safe to swim in. A pool pump is an essential to every pool, but there will be times that your pool pump keeps tripping breaker, especially after rain!
It isn’t only annoying when it trips the breaker, but it can also be dangerous while you swim. If you’re wondering why your pool pump keeps tripping breaker and how to stop it from doing so, then read on as we show you what you need to know about pool pumps and breakers.
Table of Contents
What is a Pool Pump?
You can clean your pool and manually add chemicals to it as much as you can, but it won’t be enough, especially when filtering your pool water to keep it free from bacteria! That’s where the pool pump comes along.
It’s one of the most important types of equipment you need for your pool! Without it, your pool won’t be cleaned or sanitized completely, leading to stains or bacteria floating about.
Why Pool Pump Keeps Tripping Breaker
Your pool pump’s circuit breaker used to keep your pool pump running safely and accurately. But sometimes, your pool pump may end up tripping it, causing the breaker to fail and no power in your pool pump!
It’s not only an irritating situation, but also something that may lead to danger. So how come your pool pump keeps tripping breaker in the first place?
It may be because of four reasons:
- Your circuit breaker is short circuiting from the water or corrosion collected by the pool pump.
- Debris from the rain goes into the housing, making the motor overwork. It can also be due to moisture from certain weather conditions as well.
- The pump started to rust, causing the motor to strain and work harder.
- Your wires in the breaker aren’t connected well enough.
How to Stop Your Pool Pump from Tripping Breaker
If you have experienced your pool pump tripping the breaker and causing it to fail, then you may need to have it checked out by a trusted mechanic. Or to save time and money, you might want to evaluate the pool pump itself and find the main reason why it trips your breaker.
Make sure that your pool pump is dry and free of rust. If it has rust, then you’ll need to clean it. If it was completely submerged in water, you will need to replace it.
If the pool pump is slightly wet, then dry it under the sun for a few days. Also, make sure that the wires are connected properly.
Hopefully, this article on why your pool pump keeps tripping breaker and how to stop it helped you. Do comment down below if you have any more questions or suggestions!